Page 1 of 1

Problem with GroupWise

Posted: May 6th, 2013, 9:28 am
by Rickard Rolfsson
EstablishConnection: NWSMConnectToTSA: (0XFFFEFFB2) "(SMDR-6.57.0) An internal error has occurred. Could not connect tospecified endpoint."

The backup has run without any problems before, suddenly the backups fails and the I get the message above. No updates or other changes have been done on the GroupWise servers.

The backup starts for about two minutes and then suddenly SMDR dies on the GroupWise servers, I have rebooted both the GroupWise servers and the SEP sesam server (it's running 4.2.1.41)

Suggestions anyone???

/ Rickard Rolfsson

Re: Problem with GroupWise

Posted: May 15th, 2013, 8:44 am
by jgb
Hi,

most time this is an SLP problem. Please check with "slptool findsrvs smdr.novell" on DataMover server and on the Groupwise server himself, that the SMDR service is registered correct.
Please check, that you have installed the latest Sesam Backup Client on the Groupwise Server and the latest Sesam Baclkup Client AND Sesam Novell Client (http://download.sep.de/netware/OES-Linu ... E.i586.rpm ) on the DataMover Server.
Check eDir Server Certificates of the GroupWise server (valid ?).
In case of GroupWise 2012 take care, that the DataMover Server must have rights to the GroupWise Server.

From SEP WIKI:
A valid access from the Sesam DataMover to the SEP sesam client on the Groupwise server respectively the cluster nodes is required. Run the following command on the Groupwise server respectively on each cluster node
/opt/sesam/bin/sesam/sm_setup/set_client <hostname of Sesam DataMover>


JGB